Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 37)

SierraFC M8‐4 Protocol Analyzer User Manual 37
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
 Trigger on a pattern or sequence of patterns (see “Trigger Setup” on page 145 ).
 Configure trace capture memory (see “Project Settings” on page 174 ).
 Select file to save trace capture in memory (see “Project Settings” on page 174 ).
 Include a project note (see “Notes” on page 174 ).
Saving a Trace Capture
You can save a Trace Capture for review at a later time using the Save As dialog.
Figure 2.6: Save As Dialog
You can limit the range of the saved file. You can save:
 All Traces
 A range between selected cursors
 A range between selected level of decoding. The levels allowed are dependent
on the traffic in the trace. A trace with only Switch traffic might have the follow‐
ing levels available: ELS Cmd, Frame, GS Cmd, Sequence and SW Cmd, whereas a
read‐write trace might have Frame, SCSI Cmd and Sequence available.
 A range between selected timestamps. Specify the time format from the drop‐
down list.
Save Filtered Sample checkbox saves a trace file without filtered data.