Leds – Teledyne LeCroy SierraFC M8-4 User Manual User Manual
Page 13
SierraFC M8‐4 Protocol Analyzer User Manual
13
Teledyne LeCroy
On the back, the Analyzer has:
Power In
STX SYNC Expansion Card In/Out data ports (optional)
Figure 1.3: Back Panel
LEDs
LEDs support each port link, with the following functionality (refer to
):
Trigger
Illuminates when a trigger occurs.
Blue
Error
Illuminates when an error occurs.
Red
Link
Illuminates when a link is established.
Yellow
Speed
Has two LEDs per FC port pair.
Orange
Speed LEDs are off when there is no link.
If only P1 or P2 (or P3 or P4) has valid traffic, the LED pair shows the port speed,
as shown in the table below.
If P1 and P2 (or P3 and P4) have separate link speeds, the LED pair toggles
between the port speeds, as shown in the table below.
If P1 and P2 (or P3 and P4) successfully link, the LED pair shows the link speed,
according to the following table:
Speed
P1 (P3)
P2 (P4)
1 Gbps
Off
Off
2 Gbps
Off
On
4 Gbps
On
Off
8 Gbps
On
On
Frame
Green
After the link is established, indicates traffic on the bus.