Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 24)

Teledyne LeCroy Connecting via Ethernet
24 SierraFC M8‐4 Protocol Analyzer User Manual
Connecting via Ethernet
The Ethernet connection can have any of these configurations:
1. Analyzer connected to a network using a hub, switch, Gigabit Ethernet interface, or
similar device.
2. Analyzer connected to the host machine (machine running the application
software), using a hub, switch, Gigabit Ethernet interface, or similar device.
3. Analyzer connected directly to the host machine using an Ethernet cable.
Connecting to a Network
When connected to a network, the analyzer can communicate with the DHCP server to
establish a connection. The DHCP server continually sends the next available IP address
to the analyzer until the software starts.
The STX products use the following ports:
TCP Ports: UDP Ports:
2000 30654 ‐ 30655
TCP Ports: UDP Ports:
Summit:
4000 ‐ 4003 4012 ‐ 4014
SierraFC M8‐4:
4000 ‐ 4003
4015 ‐ 4017
Voyager:
4000 ‐ 4003
4018 ‐ 4020