Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 163)

SierraFC M8‐4 Protocol Analyzer User Manual 163
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
number of times that the pattern must occur before triggering or proceeding in the
trigger sequence.
Figure 2.123: Number of Occurrences
Note:
The Events on each link are counted independently, causing a trigger whenever the number of
occurrences on any link equals the specified value.
Triggering Order

As triggering patterns are defined and added, they are displayed in the Project Overview
pane sequentially in the order that they were entered under the Trigger category. When
the project runs, the analyzer detects the occurrence of each pattern in order and triggers
on the last one.
You can re‐order the sequence of triggering patterns. To change the sequence order,
highlight a trigger pattern and use the Up or Down arrow to move it to a new position.
Figure 2.124: Triggering Order