Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 152)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
152 SierraFC M8‐4 Protocol Analyzer User Manual
Timers/External
Selecting a timer for a trigger in the Any Trigger Mode limits the time that the analyzer
looks for selected triggering conditions before triggering. The timer activates when the
Project runs. If none of the selected triggering conditions occurs during the timer’s active
time, the Analyzer triggers at the end of the time set for the timer.
Timer
You can set a timer independently of any other trigger selection, to cause an
unconditional trigger after a set time.
Double‐click Timer in the Pattern window to open the Add Timer Pattern dialog.
Figure 2.118: Add Timer Dialog
Check a Time Unit, enter the Timer Value, and click OK.
Note: The timer and timeout resolution is limited to one DWORD. The minimum value is 12‐13
DWORD.