Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 145)

SierraFC M8‐4 Protocol Analyzer User Manual 145
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
 FC‐AE 1553
 FC‐ASM
 FC‐VI
 FC‐AV Container
 ARINC 818
 Generic FC Feat
 RNID Gen. Top. Dis. Page
Protocol Errors
Double‐click Protocol Errors to open the Add Protocol Error Pattern selection dialog.
Figure 2.114: Protocol Error Pattern Dialog
Check protocol error(s) and then click OK.
Note: The Analyzer counts the errors in Frame base, while Infusion counts the errors in DWORD base
hence, there is a difference in captured errors between the Analyzer and Infusion. The errors in
Infusion are always higher.
Trigger Setup
The Trigger tab in the analysis project dialog allows you to specify when the analyzer
completes a data capture. Three trigger modes are available: The default Snapshot,
Manual Trigger, and Pattern/Event Trigger.