Teledyne LeCroy SierraFC M8-4 User Manual - Manual (Page 154)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
154 SierraFC M8‐4 Protocol Analyzer User Manual
Basic Patterns
Connect/Disconnect
See “Basic Patterns” on page 44 .
Symbol
Double‐click Symbol in the Pattern window to open the Add Symbol Pattern dialog.
Figure 2.121: Add Symbol Pattern Dialog
Choose a symbol type by checking either the K Symbol or D Symbol option.
If you choose the K symbol, click the down arrow in the Symbol dropdown list, choose a
symbol on which to trigger, and click OK.
The D Symbol choice does not have a down arrow.
Count is the expected number of occurrences on each link. Default is 1.
Ordered Set
See “Ordered Set” on page 45 for more information.
Basic Link Service
See “Basic Link Service” on page 46 for more information.
Link Control Frame
See “Link Control Frame” on page 47 .
FCP Patterns
FCP SCSI Command
See “FCP Patterns” on page 48 for more information.
FCP Frame Information Unit
See “FCP Frame Information Unit” on page 49 for more information.