Teledyne LeCroy AORM - Advanced Optical Recording Measurements - Manual (Page 17)

AORM Software Package
923133 Rev A ISSUED: June 2013
15
Measurement Table
When the Parameter view is selected, up to 4 additional parameters, which are related to the selected
measurement, are displayed. The following table shows these additional parameters. For parameters
that can be shown in the XY display, it also shows the parameter that is used for the X axis.
Measurement Parameters XY
(setup for custom parameters) (x axis)
dp2c (s) t@pit,pwid,pnum t@pit
EDGESH t@pit,pwid,pnum t@pit
EES (s) pwid,ptop,pbase,pnum n/a
BES (s) pwid,ptop,pbase,pnum n/a
PAA pwid,ptop,pbase,pnum n/a
Pit width t@pit, ptop,pbase,pnum t@pit
timj t@pit, ptop,pbase,pnum t@pit
Pit base pwid,ptop,pbase,pnum pwid
Pit top pwid,ptop,pbase,pnum pwid
Pit minimum pwid,ptop,pbase,pnum pwid
Pit middle pwid,ptop,pbase,pnum pwid
Pit asym pwid,ptop,pbase,pnum n/a
Pit max pwid,ptop,pbase,pnum pwid
Pit num pwid,ptop,pbase n/a