Teledyne LeCroy AORM - Advanced Optical Recording Measurements - Manual (Page 20)

18
ISSUED: June 2013 923133 Rev A
CREATING AND ANALYZING HISTOGRAMS
Selecting the Histogram Function
Histograms are created by graphing a series of waveform parameter measurements. The first
step is to define the waveform parameter to be histogrammed. The next figure shows a screen
display accompanying the selection of a frequency (freq) parameter measurement for a sine
wave on Channel 1.
Four waveform cycles are shown, which will provide four freq parameter values for each
histogram on each sweep. With a freq parameter selected, a histogram based on it can be
specified.
Histogram Trace Setup Dialog
Each time a waveform parameter value is
calculated it can be placed in a histogram bin.
Enter the #Bins from 20 to 2000.
You can set from 20 to 2 billion parameter
value calculations for histogram display in the
#Values
field.