Vanguard DigiTMR - Manual (Page 27)

REV 3 DIGITMR USER’S MANUAL
22
If you do not wish to save the test shot in memory, press the [2] key, and then
continue to step b.
b. The following screen will be displayed:
Press the
[1]
key (NO) to indicate that there is no insertion resistor.
c. The following screen will be displayed:
Press the [1] key (WINDOW = 1 SEC) to select the 1-second timing window.
NOTE
The 1-second timing window is used for breaker timing. The 10-second and
20-second timing windows are used for circuit-switcher timing.
d. The following screen will be displayed:
Press the [1] key (Internal Trigger) to select the internal trigger.
e. The following screen will be displayed:
Press the
[1]
key (OPEN) to select the OPEN timing operation.
TIMING MODE
1. OPEN 2. CLOSE
3. O-C 4. C-O
5. O-C-O
TRIGGER MODE:
1. Internal Trigger
2. External Trigger
TIMING WINDOW:
1. WINDOW = 1 SEC
2. WINDOW = 10 SEC
3. WINDOW = 20 SEC
INSERTION RESISTOR?
1. NO
2. YES