Vanguard DigiTMR User Manual
Page 71
REV 3 DIGITMR USER’S MANUAL
66
3.10.3. Setting the DigiTMR’s Internal Clock
The DigiTMR has an internal clock with a lithium battery. The battery lasts approximately three
years. When a timing shot is stored in the EEPROM, the time and date are also stored with the
shot. To set the clock, follow the steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SET-UP).
b. The following screen will be displayed:
Press the
[4]
key (NEXT PAGE).
c. The following screen will be displayed:
Press the
[3]
key (SET CLOCK).
d. The following screen will be displayed:
Enter the hours and minutes using the numeric keypad.
e. The screen will be updated as shown:
Enter the Month, Date, and Year using the numeric keypad. The clock will be set, and
you will then be returned to the “START-UP” menu.
TIME: HH:MM:00
09:31:15 11:35
DATE: MM/DD/YY
03/11/09
TIME: HH:MM:00
09:31:15
1. SHOT DESCRIPTION
2. COMPUTER ITF
3. SET CLOCK
4. SET PRINT MODE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS