Vanguard DigiTMR - Manual (Page 50)

DIGITMR USER’S MANUAL REV 3
45
3.8.2. Printing a Timing Shot Directory of Shots Stored in the EEPROM
A listing of all the shots stored in the DigiTMR’s EEPROM can be printed on the built-in thermal
printer using the steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SET-UP).
b. The following screen will be displayed:
Press the [3] key (SAVE / RESTORE).
c. The following screen will be displayed:
Press the [3] key (SHOT DIRECTORY).
d. The following screen will be displayed:
Press the [1] key (SHORT DIRECTORY).
NOTES
• If the SHORT DIRECTORY option is selected, the DigiTMR will print the
shot numbers and header information of the last ten timing shots stored
in the EEPROM.
• If the FULL DIRECTORY option is selected, the DigiTMR will print the shot
numbers and header information of all timing shots stored in the
EEPROM.
• A typical shot directory printout is shown in Figure 18.
1. SHORT DIRECTORY
2. FULL DIRECTORY
“STOP” TO QUIT
1. SAVE SHOT
2. RESTORE SHOT
3. SHOT DIRECTORY
4. ERASE SHOT
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS