Vanguard DigiTMR - Manual (Page 63)

REV 3 DIGITMR USER’S MANUAL
58
3.9.2. Printing a Breaker Test Plan
To print a breaker test plan:
a. Start from the “START-UP” menu:
Press the [3] key (SET-UP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the
[2]
key (PRINT TEST PLAN).
e. The following screen will be displayed listing the first test plan:
Press the [PAPER ∧ Contrast] or [PAPER ∨ Contrast] key to scroll through the
list of stored test plans. Press the [ENTER] key when you have found the test plan that
you would like to print.
f. The selected test plan will be printed and you will be returned to the “START-UP” menu.
A typical test plan printout is shown in Figure 19.
TEST PLAN #: 01
121PA50/63
ABB
JUST A DEMOPLAN
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS