Vanguard DigiTMR - Manual (Page 69)

REV 3 DIGITMR USER’S MANUAL
64
3.10.2. Setting the Measurement Units
The DigiTMR supports both English and Metric calculations from the breaker’s travel
parameters. To change the measurement units:
a. Start from the “START-UP” menu:
Press the
[3]
key (SET-UP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the [1] key (ENGLISH) for English measurement units. The measurement units will
be set to English, and you will be returned to the “START-UP” menu.
Press the [2] key (METRIC) for Metric measurement units. The measurement units will
be set to Metric, and you will be returned to the “START-UP” menu.
NOTE
When the measurement units are changed, the DigiTMR will re-calculate the
velocity and convert the readings of test shots to the new measurement units.
For example, if a test shot was taken using the English measurement units and
then the units of measure is changed to Metric, the velocity and test readings
will be automatically converted to Metric.
Press the [3] key (ROTARY ENCODER) if you would like to set the measurement units for
the rotary encoder. The following screen will be displayed:
ROTARY ENCODER:
1. ENGLISH (In./deg)
2. METRIC (MM/deg)
SELECT UNITS
1. ENGLISH
2. METRIC
3. ROTARY ENCODER
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS