Vanguard DigiTMR - Manual (Page 38)

DIGITMR USER’S MANUAL REV 3
33
3.6.3. Checking Cable Hookups
To check the cable hookups:
a. Start from the “START-UP” menu:
Press the [4] key (DIAGNOSTICS).
b. The following screen will be displayed:
Press the [2] key (CHECK HOOKUP).
c. The following screen will be displayed:
Press the [START] key.
d. The test results will be displayed on the screen as shown below and also printed on the
thermal printer:
NOTE
A contact closure is shown as “C” on the screen and on the printout. An open
contact is shown as “-“ on the screen and on the printout.
1 2 3
C - -
MAKE SURE BREAKER IS
IN CLOSED POSITION
THEN PRESS “START”
1. SLOW CLOSE TEST
2. CHECK HOOKUP
3. TEST TRANSDUCER
4. NEXT PAGE
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS