Using the heart rate parameter control panel – ZOLL Propaq MD Rev A User Manual
Page 95
Configuring Heart Rate (HR) Meter Alarms
9650-0805-01 Rev. A
Propaq MD Operator’s Guide
7-7
Using the Heart Rate Parameter Control Panel
To configure alarms through the Heart Rate Parameter Control Panel, use the navigation keys to
highlight and select the Heart Rate meter and display the HR/PR Parameter Control Panel:
On the HR/PR Parameter Control Panel, you can enable/disable alarms and set high and low
alarm limits (as described previously).
You can also configure these HR/PR options:
•
HR/PR Selected Source
-- sets the source of the HR/PR (ECG, IBP channel 1, SpO2,
IBP channel 2, or IBP channel 3).
•
Current Source --
shows the selected HR/PR source.
•
ECG Sweep Speed --
sets the ECG sweep speed on the display (25 mm/s or 50 mm/s).
HR/PR
Lower
Upper
HR/PR Alarm
40
100
HR/PR Tone
Low
ECG
Current Source
ECG
ECG Sweep Speed
25 mm/s
HR/PR Selected Source