Yokogawa ADMAG AXF - Manual (Page 9)

IM 01E20D01-01E 2-1
2. HANDLING PRECAUTIONS
2. HANDLING PRECAUTIONS
This instrument has been inspected carefully at the
factory before shipment. When the instrument is
delivered, visually check that no damage has occurred
during transportation.
Read this section carefully as it contains important
information on handling this instrument. Refer to the
relevant sections for information not contained in this
section. If you have any problems or questions, please
contact Yokogawa sales office.
2.1 Checking Model and
Specifications
The model code and specifications are found on the
data plate located on the outside of the case. Check
that the model code and specifications match what you
have ordered.
Be sure you have your model number and serial
number available when contacting Yokogawa.
F0201.EPS
0038 *1)
Figure 2.1.1 Data Plate (Integral Flowmeter Type)
*1) In case of the sizes of 2.5 to 25mm (0.1 to 1.0 in.) ,
“0038” is not described.
F0202.EPS
0038
*1)
Figure 2.1.2 Data Plate (Remote Flowtube Type)
*1) In case of the sizes of 2.5 to 25mm (0.1 to 1.0 in.) ,
“0038” is not described.
In case of the sizes of 500 to 2600mm (20 to
104 in.), CE marking and “0038” are not described.
2.2 Accessories
Check that the parts shown below are included in the
package:
᭹ Remote Flowtube(size 2.5 to 1000 mm(0.1 to 40 in.)):
Centering device (wafer type only): 1 pc.
Hexagonal wrenche: 2 pcs. (one each of 1.5 mm
and 3 mm nominal sizes)
᭹ Integral Flowmeter:
Centering device (wafer type only): 1 pc.
Hexagonal wrenche: 2 pcs. (one each of 1.5 mm
and 3 mm nominal sizes)