Changing the analog retransmission output – Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 32
32
IM 04L31A01-02E
Changing the Analog Retransmission Output
MAN must be set for the MODE using the procedure above.
1.
Use the
arrow keys
to move the cursor to the desired control loop
2.
Press the
OUT soft key
. The Output Value Setting window appears.
3.
Change the output value using the
up and down arrow keys
. The currently set
control output value is displayed in the window.
Switching between Automatic and Manual for the DIO Operation Monitoring
You can switch the output mode for the DO specified in the DIO Operation Monitoring
Function. When set to AUTO, the internal switch status is output. When set to MAN, you
can switch the direct output value between 0 and 1.
1.
Use the
arrow keys
to move the cursor to the desired control loop.
2.
Press the
MODE soft key
.
A pop-up window switching between auto and manual appears.
Auto/manual switching window
3.
Select AUTO or MAN using the
up and down arrow keys
.
4.
Press the
DISP/ENTER key
to confirm the changes.
Changing the DO Output for the DIO Operation Monitoring
MAN must be set for the MODE using the procedure above.
1.
Use the
arrow keys
to move the cursor to the desired control loop
2.
Press the
OUT soft key
. The Output Value Setting window appears.
3.
Change the output value using the
up and down arrow keys
. The currently set
control output value is displayed in the window.
Switching the Operation Mode