Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 38)

38
IM 04L31A01-02E
Executing Several Program Patterns
You can execute multiple program patterns whose loop numbers do not overlap.
Switching Pattern Numbers
1. Press the PT NO. soft key in the program selection screen.
The pattern number switching pop-up window appears. The currently set pattern
numbers are displayed in the window.
2. Select a pattern number using the up and down arrow keys.
3. Press DISP/ENTER key to confirm the changed settings.
To close without saving, press the ESC key .
Program Operation Start
1. Press the RUN soft key .
The program operation start pop-up window appears.
2. Press the DISP/ENTER key . The screen changes to the program operation display.
Displaying the Program Selection Display
1. Press the SEL PNL soft key .
The screen changes to the program selection display.
Executing a Separate Program Pattern
1. Repeat the above procedure as necessary.
Switching the Displayed Pattern in the Program Operation Display
1. Press the left or right arrow keys to switch the displayed pattern.
Program Control Setup Operation
Program Control Setup Operation Sequence
First, set the control functions of the loops to be used (see below). Next, set the
program control (see page 39).
Setting the Control Operation of the Loops to Be Used
This section explains only the settings specific to the program control.
• Control > Control action, Input setting setup screen
For a description of the setup procedure, see pages 11 and 12.
Select the operation status when a power
failure occurs during program control and
the power recovers.
• [Continue]: Continues program control.
• [Manual]: Switches the loop to manual
operation.
• [Reset]: Resets program control.
Select [On].
Program Control Function (/PG1 and /PG2 Options)