Yokogawa PC-Based MX100 - Manual (Page 129)

App-1
IM MX180-01E
Append
x
3
2
1
4
5
App
Index
Appendx 1 Confgurng/Removng the Frewall
Check the following before attempting to configure or remove a firewall.
• Check the internet connection status using the ping command. If the ping fails, check
the cables, hub, IP address settings, and other factors to determine the cause.
• Check that procedures performed on the software are correct.
If the problem cannot be solved after taking the above measures, it is likely that there will
be problems with the firewall settings. Configure or remove the firewall according to the
following procedure.
Note that the following procedure describes the MX100 Standard, but it applies to the
MX100 Calibration Software as well.
Appendx