Yokogawa PC-Based MX100 - Manual (Page 34)

2-20 IM MX180-01E
Settng the Scale (Only When Scalng)
8. Select the Use check boxes under Scale to enable changing of the scale.
9. Select the decimal point position from the Point list box for Scale.
10. Click the Min box or Max box under Scale and enter the minimum or the maximum
value of the scale.
11. Click the Unit box and enter the unit of the scaled value.
Settng the Reference Channel for Dfference Input (Vald Only When Measurng
the Dfference wth Respect to the Measured Value of the Reference Channel)
12. Select the Use check box under Difference Input.
13. Select the reference channel for the difference input from the Ref. Ch. list box
under Delta.
Settng the Remote RJC Reference Channel (Vald Only When the Input Mode Is
Set to RRJC (TC)
14. Select the reference channel for the remote RJC from the Ref. Ch. list box under
RRJC.
Note
If moving from the Channel screen to the Display Setup or Monitor screen, if the differential
input reference channel or remote RJC reference channel setting is inappropriate the following
message appears.
Yes: Disable measurement channels with inappropriate settings (clear the Monitor check box in
the Channel screen) and move to the Display Setup or Monitor screen
No: Change the settings of the measurement channels with inappropriate settings without
moving to the next screen
Message
Settng the Tme Constant of the Frst-Order Lag Flter (Vald Only When the
Input Mode Is Set to Somethng Other than DI)
15. Select the time constant from the Filter list box.
Settng the Burnout (Vald Only When the Input Mode Is Set to TC)
16. Select the direction in which the measured value is set off the range (+OVER or
–OVER) when a burnout occurs from the Burnout list box.
Settng the RJC (When the Input Mode Is Set to TC)
17. Click the Type box under RJC and select Internal or External.
18. If you select External, click the Volt box under RJC and enter the compensation
voltage.
2.4 Settng the Measurement Condtons (Settng the Measurement Channels)