Yokogawa PC-Based MX100 - Manual (Page 24)

2-10 IM MX180-01E
3. Click the Current Configuration tab followed by the Reconfigure based on actual
config. button.
A dialog box with the message “Module settings which do not match the current software
configuration will be initialized.” appears.
Click here Click here
Note
If the × mark remains even after reconfiguring the system numerous times, see the corrective
action described for “The connected input/output module is not detected” in section 5.1.
4. Click the OK button.
The current module configuration is matched to the actual configuration.
Current module configuration
Settng the A/D Integraton Tme
1. Click System to show the System setup screen.
2. From the A/D Integration Time list box, select AUTO, 50 Hz, or 60 Hz.
2.2 Confgurng the System, Settng the Wrte Mode of the CF Card, and Formattng the CF Card