Yokogawa PC-Based MX100 - Manual (Page 35)

2-21
IM MX180-01E
Integrat
on Mon
tor
3
2
1
4
5
App
Index
Select the reference channel for difference input*
Enter the tag comment (up to 30 characters)
Unit (up to six characters, only when the Use check box of Scale is selected)
Enter the tag number (up to 15 characters)
Select the remote RJC reference channel (only when the input mode is set to RRJC (TC))
Check here to measure the difference input (difference with respect to
the measured value of the reference channel)*
* Cannot be used when Mode is set to RRJC
Set the RJC (only when the input mode is
set to something other than DI)
Set the burnout (only when the input mode is
set to something other than DI)
Set the time constant of the first-order lag filter
(when the input mode is set to something other than DI)
Importng Tag Numbers and Tag Comments
You can import just the tag numbers and tag comments from the saved setup data and
replace the current tag numbers and tag comments with the imported information.
From the File menu, choose Import Tag. Then, select an MX100 project file (a file with
the .mxp extension) in the Open dialog box to import the tag numbers and tag comments.
Select the MX100 project file (file with .mxp extension)
you wish to import
Note
When you carry out the procedure above, the tag numbers and tag comments of computation
channels are also imported.
2.4 Settng the Measurement Condtons (Settng the Measurement Channels)