GW Instek PSU-Series User Manual - Manual (Page 84)

PSU Series User Manual
84
Series Operation Only operate the power supplies in series if the
units are configured correctly.
1. Turn on both units. When connected in series
unit will only show the voltage and current of
their own unit.
Unit #1
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
Unit #2
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
2. Operation of both units is the same
as for a single unit. Each unit will
only draw as much power as is
programmed. Please see the basic
operation chapter for details.
Page 51
3. Press the Output key on
each unit to begin. The
output LED will become lit.
Output
CAUTION
Only operate the power supplies in series if using
units of the same model number.
Only a maximum of 2 units can be used in series.
CAUTION
Ensure that the insulation capacity of the wiring is
sufficient when connected in series. See page 32
for insulation capacity and grounding details.