Badger Meter B3000 - Manual (Page 15)

Programming Manual
Page 15 March 2014
Buttons
MENU – Switches between normal running and programming modes
UP Arrow (
▲) – In programming mode scrolls forward through the parameter choices and increments
numeric variables
RIGHT Arrow (
►) – In programming mode scrolls backward through the parameter choices and moves the active
digit to the right
ENTER – Used to save programming information, advance to the next programming parameter, and in the
reset process
TOTAL FLOW RESET – This touch sensor button allows the total to be reset without opening up the case This button
pertains to the explosion proof version only
OTE: N The “through the glass” touch sensor button is currently under development in the explosion proof version
of the B3000
Special Functions
MENU + ENTER – Simultaneously press and hold to reset the current totalizer
MENU - Press and hold menu for three seconds to enter extended programming mode
UP Arrow (
▲) + Right Arrow (►) – Simultaneously press and hold to show the firmware version number, then the
grand total
UP Arrow (
▲) – In run mode increases display contrast
RIGHT Arrow ( ►) – In run mode decreases display contrast
Modes
RUN – Normal operating mode
PROGRAM – Used to program variables into the display
EXTENDED PROGRAM – Used to program advanced variables into the display
TEST – Used as a diagnostic tool to show input frequency and totalizer counts
If your monitor was ordered with a Blancett flow meter, the two components ship from the factory configured as a set If the
monitor is a replacement, the turbine’s K factor changed, or the monitor is used with some other pulse generating device;
programming is necessary