Badger Meter B3000 - Manual (Page 16)

Compact Digital Flow Monitor, Model B3000
Page 16 March 2014
Programming Using Frequency Output Turbine Flow Meters
Each Blancett turbine flow meter is shipped with either a K factor value or frequency data If frequency data is provided, the
data must be converted to a K factor before programming the monitor K factor information, when supplied, can usually be
found on the neck of the flow meter or stamped on the flow meter body The K factor represents the number of pulses per
unit of volume (see K FACTORS EXPLAINED on page 38 ) The K factor is required to program the monitor
Essentials
The B3000 monitor is engineered to provide several levels of programming tailored to the needs of the user The first or
standard level provides access to the most commonly used setup parameters bypassing the more advanced settings The first
level programming is entered by pressing and holding MENU for about one second
The second level or extended settings are accessed by pressing and holding MENU until the extended programming
menu starts
With the standard and solar liquid monitors there is a third level For the most basic unit setup choices the B3000 monitor
employes a simple and advanced setup option accessed through the Rate SU parameter If Simple is selected the rate and total
choices are reduced to the five most common combinations avoiding the need to make unit and interval choices
Liquid Meters Standard Solar Advanced I/O
Basic Functions Press MENU for about one second and then release
Extended Functions Press and hold MENU until the extended programming menu starts
Simple Setup Select Rate SU in the extended functions and choose Simple
Not Applicable
Advanced Setup Select Rate SU in the extended functions and choose Advanced
Table 1: Display mode selection information
Enter Programming Mode
The programming modes are accessed by pressing MENU for basic functions Extended functions are accessed by pressing
and holding MENU until the first programming parameter appears
2 1
Battery
Indicator
Units
Indicator
Totalizer
Units
Totalizer
Multiplier
Numeric
Values
Function
Figure 15: Programming mode display