Badger Meter B3000 - Manual (Page 43)

Programming Manual
Page 43 March 2014
WARNING
THE HAZARDOUS LOCATION INFORMATION SPECIFYING CLASS AND GROUP LISTING OF EACH INSTRUMENT
ENCLOSURE IS MARKED ON THE NAMEPLATE OF EACH ENCLOSURE.
CAUTION
ALL UNUSED CONDUIT OPENINGS MUST BE PLUGGED. PLUG UNUSED CONDUIT OPENINGS WITH APPROVED
EXPLOSION PROOF PLUGS. PLUGS MUST BE A MINIMUM OF 1/8"THICK AND ENGAGE A MINIMUM OF 5 FULL THREADS.
OTE: N When installing device, be sure to check instrument dimensions to avoid interference with clamping ring on glass
lens and the cover on standard units
CAUTION
USE CARE TO PREVENT DIRT, GRIT OR OTHER FOREIGN MATERIAL FROM LODGING ON THREADS. IF SUCH MATERIAL
SETTLES ON THREADS, CLEAN WITH KEROSENE OR STODDARD SOLVENT*, THEN RE-LUBRICATE WITH AN APPROVED
THREAD LUBRICANT.
9 Tighten cover set screws with the 2 mm Allen wrench to prevent cover from loosening under vibration
WARNING
TO MAINTAIN THE EXPLOSION-PROOF INTEGRITY OF THE ENCLOSURE WITH A SCREW IN A TAPPED MOUNTING PAD
HOLE, THERE MUST BE A MINIMUM OF 1/16 IN. OF MATERIAL BETWEEN THE DRILL POINT AND THE BACK WALL. IF FOR
ANY REASON A SCREW WILL NOT BE THREADED INTO THE DRILLED HOLE, A MINIMUM OF 1/8 IN. OF MATERIAL MUST
REMAIN BETWEEN THE DRILL POINT AND THE BACK WALL.
WARNING
TO AVOID THE POSSIBILITY OF AN EXPLOSION, OXIDATION AND CORROSION, DO NOT USE GASOLINE OR SIMILAR
SOLVENT.