Badger Meter SRD/SRI Valve Positioners User Manual
Page 25
Input for Remote Potentiometer – Code D
This option is necessary when the positioner is not mounted
directly onto the valve but far away of it In this case a
potentiometer with 3 wires must be mounted onto the valve
to give the valve position to the controller
Remote potentiometer type to use in connection to this
option: Resistance of 5 kOhm up to 10 kOhm (for other value
of resistance please consult us)
If the following requirements are observed, the set-up
is insensitive to electrical disturbances caused by high
electromagnetic fields, EMC and HF-radiation
• Cable length max is 10 m (32 ft)
• Cable specification (not supplied):
◊ 3-wire twisted pair, shielded
◊ Shield needs to be connected on both ends to the
internal ground
◊ Shield endings need to be kept very short when
connecting to the ground
◊ An HF cable gland is not required
For more information about remote mounting,
see TI EVE0105_R
Additional Equipment
Page 25
August 2014
POS-UM-00223-EN-02