Badger Meter Fluid Management System - Manual (Page 18)

DISPENSE KEYPAD
The Dispense Keypads are responsible for the communication with the RF meters . The user starts a work order from the
keypad . After the dispense operation has been completed the keypad will receive the actual amount dispensed from the
meter . The Dispense Keypad then sends the dispense results to the Master Keypad .
The system can handle up to 36 Dispense Keypads . Up to 24 meters can be assigned to each keypad but each meter can only
be assigned to one Dispense Keypad .
System Version Screen
V3.00 2.4 GHz
The standard screen shows the system software version number . The
display will alternate between the standard screen and the Enter Pin
Number screen . The Enter Pin Number screen is used to access the
supervisor menus .
V3.00 2.4 GHz N
OTEE: N An "N" displayed in the lower left-hand corner of the system
version screen indicates a Radio Network error . See “Radio
Status” on page 23 to check the source of the error .
V3.00 2.4 GHz M
OTEE: N An "M" displayed in the lower left-hand corner of the system
version screen indicates that the Dispense Keypad has joined
an RF network, but cannot currently contact the Master
Keypad for WO authorization .
V3.00 2.4 GHz O
OTEE: N An "O" displayed in the lower left-hand corner of the system
version screen indicates that the Dispense Keypad is in System
Override mode . See “System Override (SYS) Menu” on page 24
for details .
Enter Pin No.
- - - -
Enter a user PIN to start a work order or the supervisor PIN to enter the
supervisor menus (the default PIN is 0001) .
Settings Overview / Supervisor Menus
The following configuration options are only available at the Dispense Keypad .
The default value for the Supervisor PIN is 0001 .
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 18 July 2014