Badger Meter Fluid Management System - Manual (Page 42)

Setting Up Keypads and Hoses
Adding keypads and hoses allows you to build out your entire system and send work orders to the appropriate stations .
Global Keypad Settings
Before starting, make sure your Global Keypad Settings are configured correctly .
1 . Click the SETTINGS button .
2 . Change any settings according to the
“Dispense Keypad Settings” and “Master Keypad
Settings” tables below .
3 . Click SAVE to save your changes or CANCEL
to discard the changes and return to the Main
screen .
Dispense Keypad Settings
Distance Units Specifies the units (miles or kilometers) of odometer readings for each WO .
Odometer To request that mileage be tracked, check the Odometer checkbox .
Registration To request that the car registration number be tracked, check the Registration checkbox . This
allows the system users to enter the car registration number in the Pending WO and save it to the
Completed WO .
Display Timeout Sets how long (in minutes) a PIN will be able to sit idle before timing out and forcing the user to log
back in .
Top off Timer Sets the time that the user is allowed to keep the meter open after the allotted amount of fluid has
been dispensed (timer is in seconds) .
Barcode Timeout The amount of time in increments of 10 ms to display the entered parameter on the screen after
the barcode scanner input is entered . A value of 100 will equal 1000 ms or 1s of display time . This
timeout is only used when the barcode scanner feature is selected on the keypad .
Int. Printer If you have an optional internal printer connected to the keypad, select the checkbox next to the Int.
Printer field .
Buzzer To activate the key click buzzer, check the box next to the Buzzer field .
Keypad RF Timeout Sets how long (in minutes) a PIN will be able to sit idle before timing out and forcing the user to log
back in .
Miscellaneous WO A configurable numeric input that allows the user to define what number a miscellaneous work
order gets . This would be used in the event any fluid needs to be dispensed independent of a system
work order . The miscellaneous work order number along with the user ID number will be in the work
order report . To change, simply highlight the number, delete, and enter a new number .
Auto Override Activates System Auto Override feature in all keypads so users can dispense WOs when the Master
Keypad is not operational . No supervisor intervention is required . Available with v3 .X firmware only .
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 42 July 2014