Badger Meter Fluid Management System - Manual (Page 53)

TROUBLESHOOTING
Dispense Keypad Error Messages
These error messages can be displayed by the Dispense Keypad . The associated action to reset the system is listed behind .
Message Messages at the Dispense Keypad
Hose active hit hose reset The selected meter currently has a dispense order in waiting to be processed, complete
the active order . Press RESET .
WO refused The entered work order number is not valid and has been refused by host or FMS software .
Master is down The master does not respond to a request from the Dispense Keypad
PC is down The FMS software (KPS) is not responding to the Master Keypad . Only if WO validation PC is
activated .
HOST is down The HOST (DMS) is not responding to the Master Keypad . Only if “WO Validation HOST” is
activated . Press RESET .
Host or PC is occupied Master keypad is occupied by another job . Press RESET .
Wrong hose for fluid The meter selected is not a valid meter for the fluid assigned for this WO .
↑ ↓ RF communication is in progress, please wait (10 sec) .
Meter Error Codes
The meter has several Error Codes that may display . These provide indication, at the meter, that there is an error in
communication between the meter and keypad .
Message Messages at the Meter
F01 The meter radio is not working .
To clear the error, press the RESET button on the meter .
F02 The meter is not configured to a keypad .
To clear the error code, press the RESET button on the meter .
Verify that the meter radio address is configured properly .
F03 System busy .
To clear the error, press the RESET button on the meter .
F08 Meter lost connection to network .
Out of range—network connection lost .
Keypad not powered .
Meter moved out of range of keypad .
F09 Meter not connected to a network .
First time being powered up .
Network selected is not available .
SF0
(Scale Factor 0)
The Scale Factor setting for the meter is set to 0 .000 .
To input a valid Scale Factor for the meter follow the instructions in the Change Factory Settings section
of this manual .
All other
Error Codes
Are for factory purposes only .
To clear the meter, press RESET .
Press RESET once more at the meter .
User Manual
Page 53 July 2014