Badger Meter Fluid Management System - Manual (Page 52)

Tanks and Fluids
Viewing Tank Status
To view the status of tanks in your system:
1 . Click the TANKS & FLUIDS button .
2 . View the current status and information .
To add fluid:
The information displayed includes:
•
The tank ID
• Type of fluid in that tank
• Current level of the tank
• Total capacity of the tank
Adding Fluid to a Tank
If this feature is enabled, you can add fluid upon delivery .
To add fluid to a tank:
1 . Double-click on the tank or select the tank
and click on FLUID DELIVERY .
2 . Select the unit of measure the fluid will be
delivered in (gallons, quarts, liters, or pints) .
3 . Enter the amount (in the selected units) of
fluid that is being delivered .
4 . Click SAVE to save your changes or click
CANCEL to discard your changes .
5 . Click OK on the verification screen to proceed,
or click CANCEL to edit .
If you enter an amount that brings the tank over
the capacity amount, the tank will appear in a red
“Warning” state until the proper amount of fluid is
removed via work order or the administrator goes
into the software and manually adjusts the level
of the tank .
Only the system administrator can correct a
tank level.
To exit the software, click the EXIT button .
When tank level warnings are enabled and a
fluid dispense causes the tank level to hit the
warning level, a message will appear on all part
department users screen . Click OK to clear the
message .
To exit the software, click the EXIT button .
Fluid Managment System, FMS-3 2.4 GHz RF High-End Software v3.4.1
Page 52 July 2014