UEi Test Instruments KM9106/P - Manual (Page 14)

KM9106 Operators Manual 14
5. USING THE KEYPAD
5.1 Basic Operation
Basic operation of the keypad to change the display in PAGE and LINE SCROLL
mode is detailed section 4.3. These modes give you the facility to perform the
following :-
• Page Mode displays 4 lines of data in set format, each page is predefined.
• Line scroll mode allows you to customise the display with the data you require.
5.2 QUICK key operation
To allow parameters to be viewed quickly Quintox has a number of QUICK keys.
Many of these keys have two functions.
To select an LOWER PARAMETER
parameter simply press the key i.e.
to display CO
2
and three other
values
CO2 % . . . 20.9
CO ppm . . . 0000
NETT C . . . . 0.0
XAIR O2 > 20%
To select a UPPER PARAMETER
parameter press the UPPER FUNCTION
key
-- -- -- -- -- -- -- -- -- -- -- -- --
UPPER FUNCTION
-- -- -- -- -- -- -- -- -- -- -- -- --
Followed by the UPPER PARAMETER
you require parameter key i.e.
to display NO
2
and three
other values
NO2 ppm . . . . . 0
NO ppm . . . . . 0
NETT C . . . . 0.0
CO ppm . . . . . 0
Other QUICK keys are detailed below :-
LOWER PARAMETER KEYS
NETT
to display Nett temperature plus O
2
, CO and Eff.
FLUE to display Flue temperature plus Ambient, O
2
and Prs
.
INLET to display Inlet temperature plus Ambient, O
2
and Flue
O
2
to display Oxygen reading plus CO, CO
2
and Nett
CO
2
to display Carbon Dioxide calculation or reading CO, Nett and XAIR
CO to display Carbon Monoxide plus Nett, O
2
and CO
2
AUX to display AUX1 and CxHy readings plus Nett and CO
FUEL to display chosen fuel and its parameters
EFF to display Gross efficiency plus O
2
and CO
CO
2
NO
2