UEi Test Instruments KM9106/P User Manual
Page 38
KM9106 Operators Manual
38
8.1.3 Logging
Data
Data logging is done with the handset operating in 2. QUINTOX CONTROL and by
either pressing the key or requesting an auto print, information will be
captured by the logger and stored.
The display will show the following screen to confirm information has been stored
correctly.
DATA LOGGED 0123
In the display shown above the data has been stored in location 123. Make a note of
this on any paperwork you are using for that job so that the information can be
retreived later.
8.2
Batteries
The logging handset can either be powered from the Quintox through the lead or from
its own batteries. Batteries are inserted in the back of the logger by removal of the
rear cover.
TIP:
It is advised that batteries are used at all times to ensure no data is lost or
corrupted.
Four 'AA' alkaline batteries can be used or a Nicad rechargeable equivalent, if Nicad
batteries are used they can be recharged by plugging the Quintox charger into the side
of the handset. Typical recharge time is 12 hours.
Take care to insert batteries correctly, indication of polarity is in the battery
enclosure.