UEi Test Instruments KM9106/P - Manual (Page 49)

KM9106 Operators Manual 49
11.3 Charging the Battery
It is important that the battery is charged on a regular basis. The instrument constantly
powers the internal sensors and may flatten the battery if left unattended for some
months. Connect the charger supplied with the instrument to the correct mains
supply.
Note: The correct charger type is required for your local voltage i.e. 110 or 220
volts AC
Insert the plug in the socket marked CHARGER INPUT SOCKET as detailed in
section 1.4.
The CHARGER ON GREEN LED will illuminate showing the instrument is
charging.
11.4 Changing the Paper Roll
To change the paper roll remove the printer cover by loosening the two screws
holding it down. Remove the old paper roll core and insert the new roll so that it sits
as follows :-
Feed the free end of paper into the printer through the metal slot beneath the printer
ribbon. Start the paper feed sequence until the paper has emerged from the top of the
printer, feed the loose end through the cover and refit.
TO START PAPER FEED
Press the followed by
UPPER FUNCTION key -- -- -- -- -- -- -- -- -- -- -- -- --
UPPER FUNCTION
SET
-- -- -- -- -- -- -- -- -- -- -- -- --
Pressing the key displays
Press any key to stop.
PAPER FEED
SET/CAL
PRINT