UEi Test Instruments KM9106/P - Manual (Page 32)

KM9106 Operators Manual 32
The remainder of this section explains the following :-
Setting auto-timed printing or logging
Allows information to be printed or logged automatically at set time intervals (from
10 seconds to 90 minutes). Care must be taken in setting the interval time; a standard
Quintox printout will take 30 seconds to print, it is advisable to set the interval at 2
minutes or greater if a print is requested. Turn off the printer if less than 2 minutes is
set. If greater than 5 minutes is set the Quintox will switch OFF the pump
immediately after printing and switch it ON again 3 minutes before the next print.
Disabling quintox printer
If only logged information is required without a printout then the Quintox integral
printer can be turned OFF.
Edit the printout header
You can personalise the header on the printout to your own Company name and
Telephone number. Two lines of 16 characters are available.
Changing the format of the printout
The standard printout is detailed on the previous page. You can customise a printout
to your own requirements by selecting lines from the list detailed later in this section.
7.1 Changing printout parameters
Press followed by will display the following screens :
This displays the Auto print status and
the interval time; for this example 2
minutes.
AUTO PRINT 2:00
OFF
Use or keys. To select ON or OFF and press
With Auto print ON the display will
show :-
SET
AUTO PRINT 2:00
Use or keys to select from 0:10 to 90:00 and press
ENTER
ENTER
SET/CAL
PRINT