UEi Test Instruments KM9106/P User Manual
Page 43
KM9106 Operators Manual
43
8.4.2 Capturing Data From Quintox
To capture data direct from the Quintox into a PC the RS232 port on the Quintox has
to be connected to the serial port on your PC. Using the standard RS232 lead, and
IBM/AT lead if you serial port is a 9 pin D type, connect the Quintox to the PC.
The RS232 can output in two formats, Comma Separated variable (CSV) and Binary (for
the logger).
The standard default setting is binary and will always be set if the instrument is switched
off and on. To change between the outputs press followed by .
The instrument will beep and change the output, repeat the key sequence to change back.
The format for the CSV output is as follows:-
Time Date Instability Battery Sensor Ambient Pressure
Fuel
16:28:30 20-05-96 0
49
23.5
24.5
0.3
12
K1g
K1n
K2
K3
K4
O2 Reference
Nett temp
Flue
temp
0.35 0.39 11.8
9.8 32 3
120
144
Inlet temp
Oxygen
reading
Excess
air
CO
Reading
Calculation Efficiency Losses
Dry
loss
N 8.3
28
55
3.5 83 17
8
Wet
loss
CO
Loss
NO NO2 NOx SO2 H2xc
Aux1
Aux2
7
2 20 N 21 N 12
N
N
The output will be as the example below:-
16:28:30, 20-05-96, 0, 49, 23.5, 24.5, 0.3, 12, 0.35, 00.39, 11.8, 9.8, 32, 3, 120, 144, N,
8.3, 28, 55, 3.5, 83, 17, 8, 7, 2, 20, N, 21, N, 212, N, N
Where a number is not displayed the following meanings can be taken:-
N = Not fitted
F = Fault
O = Over range (i.e. Oxygen reading 20.9% hence excess air can not be calculated)
8.4.3
Downloading Logged Data
The FIREWORKS software allows data to be downloaded from the handset. This
section is supplied to explain how to set the handset in a state ready to transmit data.
Using the lead RE5PC supplied with FIREWORKS connect the 15 pin D connector to
the handset and the 9 pin D connector to your PC serial port. Most PCs have a 9 pin D
serial port if yours has a 25 pin contact your computer supplier for a convertor.
Set the logger to DOWNLOAD data and ensure it is in READY mode.
NOTE: You will require batteries to run the logger and download the data.
SET/CAL
ENTER
AUX