UEi Test Instruments KM9106/P - Manual (Page 15)

KM9106 Operators Manual 15
UPPER PARAMETER KEYS
ALWAYS Press
UPPER FUNCTION first then
SCALE
to display Scaling setup parameters
AMBIENT to display ambient temperature plus sensor, Flue and Inlet
SO
2
to display Sulphur Dioxide reading plus Nett, O
2
and CO
NO
2
to display Nitrogen Dioxide reading plus NO, Nett and CO
NO to display Nitric Oxide reading plus NO
x
, Nett and CO
NO
X
to display the Oxides of Nitrogen reading plus NO, CO and Nett
PRESSURE to display the pressure reading plus Flue, Nett and O
2
LOSSES to display all four losses
λ to display Excess Air plus CO, Eff and CO
2
.
All measured and calculated values are detailed in Appendix A - Main Display
Parameters.
5.3 DISPLAY
HOLD
The display hold function allows you to freeze values on the instrument allowing
them to be viewed or printed. No measurements are taken once this function has been
activated. This feature gives the following benefits :-
• Data can be viewed at a particular point in the boiler tuning process.
• Multiple printouts may be obtained of the same data.
• Scales can be changed between printouts giving different units. i.e. ppm and mg/m
3
TO TOGGLE DISPLAY HOLD
Press UPPER FUNCTION
followed by
# Indicates the display is held. # NETT C . . . 0.0 #
# O2 % . . . 20.9 #
# CO ppm . . 0000 #
# EFF (G) % . . . 0.0 #
In this function only the battery level will be updated and all other parameters are
frozen. This does not apply when AUTOPRINT is ON, the time and date are also
updated in this mode.