Brother HL-S7000DN - Manual (Page 25)

Configuring your machine for a wireless network
19
3
Note
• If you configure your machine using EAP-TLS Authentication, you must install the Client Certificate issued
by a CA (Certificate Authority) before you start configuration. Contact your network administrator about the
Client Certificate. If you have installed more than one certificate, we recommend you write down the
certificate name you want to use. For details on installing the certificate, see Using Certificates for device
security uu page 65.
• If you verify your machine using the Common Name of the Server Certificate, we recommend you write
down the Common Name before you start configuration. Contact your network administrator about the
Common Name of the Server Certificate.
b
Press Menu.
c
Press a or b to choose Network.
Press OK.
d
Press a or b to choose WLAN.
Press OK.
e
Press a or b to choose Setup Wizard.
Press OK.
f When WLAN Enable? is displayed, press a or b to choose On and then press OK.
This will start the wireless setup wizard.
To cancel, press Cancel.
g The machine will search for your network and display a list of available SSIDs.
You should see the SSID you wrote down earlier. If the machine finds more than one network use a or
b
key to choose your network, then press OK. Go to step k.
If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. Go
to step h.
h Choose <New SSID> using a or b.
Press OK. Go to step i.
i Enter the SSID name. (For information on how to enter text: uu Quick Setup Guide.)
Press OK. Go to step j.
j Using a or b, choose Infrastructure when instructed.
Press OK.
For example:
Network name: (SSID)
HELLO
Communication Mode Authentication method Encryption mode User ID Password
Infrastructure EAP-FAST/MS-CHAPv2 AES Brother 12345678