Brother HL-S7000DN - Manual (Page 31)

Configuring your machine for a wireless network
25
3
a
Press Menu.
b Press a or b to choose Network. Press OK.
c Press a or b to choose WLAN. Press OK.
d
Press a or b to choose WPS w/PIN Code. Press OK.
e
When WLAN Enable? is displayed, press a or b to choose On and then press OK.
This will start the wireless setup wizard.
To cancel, press Cancel.
f The LCD will show an 8 digit PIN and the machine starts searching for a WLAN access point/router.
g Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
1 .) Go to
the WPS setting page and input the PIN which the LCD shows in step f to the Registrar and follow the
on-screen instructions.
1 The Registrar is normally the WLAN access point/router.
Note
The setting page is different, depending on the brand of WLAN access point/router. See the instructions
supplied with your WLAN access point/router.
Windows Vista
®
/Windows
®
7
3
If you are using your computer as a Registrar, follow these steps:
Note
• To use a Windows Vista
®
or Windows
®
7 computer as a Registrar, you need to register it to your network
in advance. See the instructions supplied with your WLAN access point/router.
• If you use Windows
®
7 as a Registrar, you can install the printer driver after the wireless configuration by
following the on-screen instructions. If you want to install the full driver and software package, follow the
steps uu Quick Setup Guide for installation.
1 (Windows Vista ® )
Click the button and then Network.
(Windows
®
7)
Click the button and then Devices and Printers.
2 (Windows Vista
®
)
Click Add a wireless device.
(Windows
® 7)
Click Add a device.
3 Choose your machine and click Next.
4 Input the PIN which the LCD shows in step f and then click Next.