Brother HL-S7000DN - Manual (Page 39)

Control panel setup
33
4
DNS Server
4
Primary DNS Server IP Address
4
This field specifies the IP address of the primary DNS (Domain Name System) server.
Secondary DNS Server IP Address
4
This field specifies the IP address of the secondary DNS server. It is used as a backup to the Primary DNS
server address. If the Primary server is unavailable, the machine will contact the Secondary DNS server.
IP Boot Tries
4
This field displays the number of attempts the machine will try to obtain an IP address when the Boot Method
is set to any setting except Static.
APIPA
4
The setting of On will cause the print server to automatically allocate a Link-Local IP address in the range
(169.254.1.0 - 169.254.254.255) when the print server cannot obtain an IP address through the Boot Method
you have set. (See Boot Method uu page 31.) Choosing Off means the IP address does not change, when
the print server cannot obtain an IP address through the Boot Method you have set.
IPv6
4
This machine is compatible with the Internet protocol IPv6. If you want to use the IPv6 protocol, choose On.
The default setting for IPv6 is Off. For more information on the IPv6 protocol, visit
http://solutions.brother.com/.
Note
• If you set IPv6 to On, turn off the power switch and then turn it back on to enable this protocol.
• After you choose IPv6 On, this setting will be applied to both the wired and wireless LAN interface.
Ethernet (wired network only)
4
Ethernet link mode. Auto allows the print server to operate in 1000BASE-T full duplex, 100BASE-TX full or
half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.
Note
• If you set this value incorrectly, you may not be able to communicate with your print server.
• For details about 1000BASE-T full duplex operation, see Gigabit Ethernet (wired network only)
uu
page 45.
Wired Status
4
This field displays the current wired network status.