Canon imagePROGRAF iPF8400S - Manual (Page 102)

iPF8400S Basic Guide
102
Tro
ubl
esho
otin
g
P
rob
lem
s Reg
ard
ing Pap
er
Troubleshooting
Problems Regarding Paper
Clearing Jammed Roll Paper ....................................................................................................................... 102
Clearing a Jammed Sheet ............................................................................................................................ 105
Roll paper cannot be inserted into the paper feed slot ................................................................................. 107
Cannot load sheets ...................................................................................................................................... 107
Paper is not cut straight ................................................................................................................................ 107
Paper is not cut ............................................................................................................................................ 108
The media take-up unit continues rotating ................................................................................................... 108
The size of clear film cannot be detected ..................................................................................................... 109
Margins are wide .......................................................................................................................................... 109
When printing on thin roll paper, the printed surface becomes scratched .................................................... 110
Clearing Jammed Roll Paper
If roll paper jams, follow the steps below to remove jams.
1 Turn the printer off. (See "Turning the Printer On and Off.")➔User's Guide
2 Open the Top Cover.
Note
• If the leading edge of the roll jams in the carriage such as when the paper curls strongly,
you may be able to avoid paper jamming by setting the roll cutting method to Manual
and setting the detection of paper leading edge to [Off].
(See "Specifying the Cutting Method for Rolls.")➔User's Guide
3 If the Carriage is out, move the Carriage out of
the way, away from the paper.
Caution
• If you push the Carriage to the left edge, the blade of the Cutter Unit will be lowered in
preparation to cut the paper. Be careful not to pinch your fingers between the Carriage
and Platen if you have pushed the Carriage to the left edge or if a paper jam occurs
during cutting.