Canon imagePROGRAF iPF8400S - Manual (Page 135)

iPF8400S Basic Guide
135
Er
ror M
essa
ge
Me
ssa
ges
r
egar
ding
pa
per
The paper is too small.
Replace paper with A4/LTR (vertical) or larger
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print
a test print sheet or other printer
status information.) Replace the paper with paper of A4/Letter (vertical) size or larger as follows.
1. Press
▲ or ▼ to select Change Paper, press the OK button, and remove the
paper.
(See "Removing Sheets.")➔P.24
2. Switch to paper A4/Letter (vertical) or larger.
(See "Loading and Printing on Sheets.")➔User's Guide
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Replace roll with 10 in. wide or larger roll.
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or
other printer status information.) Replace the roll with a roll 10 inches in width or larger as
follows.
1. Press
▲ or ▼ to select Change Paper, and then press
the OK button.
(See "Removing the Roll from the Printer.")➔P.18
(See "Removing Rolls From the Roll Holder.")➔User's
Guide
2. Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")➔P.12
(See "Loading Rolls in the Printer.")➔P.14
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the
OK button.
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is set to
Pause or Hold Job, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in the
printer driver. Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
However, note that this error may cause paper jams and
affect the printing quality.
Press ▲ or ▼ to select Stop Printing, and then press the
OK button.
Follow these steps to replace the roll to match the width
specified in the printer driver.
1. Press
▲ or ▼ to select Change Paper, and then press
the OK button.
(See "Removing the Roll from the Printer.")➔P.18
(See "Removing Rolls From the Roll Holder.")➔User's
Guide
2. Replace with paper of the width configured in the printer
driver.
(See "Attaching the Roll Holder to Rolls.")➔P.12