Canon imagePROGRAF iPF8400S - Manual (Page 108)

iPF8400S Basic Guide
108
Tro
ubl
esho
otin
g
P
rob
lem
s Reg
ard
ing Pap
er
Cause Corrective Action
position.
Paper rises by the ends of the cut
position before it is cut. Reload the paper correctly.
You are using paper that cannot be cut
with the Cutter Unit. Specify Manual in Cutting Mode in the Control Panel menu and use scissors
or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")➔User's Guide
The Cutter Unit is not installed correctly. Reinstall the Cutter Unit correctly.
(See "Replacing the Cutter Unit.")➔P.45
The Cutter Unit blade is worn out. Replace the Cutter Unit.
(See "Replacing the Cutter Unit.")➔P.45
Cut Speed is not configured correctly in
the Control Panel menu. Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")➔P.64
During cutting, printed documents fall
out at an angle. In the Control Panel menu, set Cutting Mode to Eject. Hold documents after
printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")➔User's Guide
Paper is not cut
Cause Corrective Action
In the printer driver, No or Print Cut Guideline is specified
in Automatic Cutting. Specify Yes in Automatic Cutting in the printer driver.
(See "Page Setup Sheet.")➔User's Guide
(See "Paper Detailed Settings Dialog Box.")➔User's
Guide
In the Control Panel menu, Cutting Mode is set to Eject or
Manual. If the Cutting Mode is Eject, press the Cut button to cut
the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
(See "Specifying the Cutting Method for Rolls.")➔User's
Guide
The Cutter Unit is not installed. Install the Cutter Unit.
(See "Replacing the Cutter Unit.")➔P.45
Rolls are not cut when you are using the Media Take-up
Unit. Either cut the roll paper by pressing the Cut button or lift the
Release Lever and cut the roll with scissors.
(See "Removing Printed Documents from the Media
Take-up Unit (Optional).")➔User's Guide
The media take-up unit continues rotating
Cause Corrective Action
There is a foreign object in the path of the Media Take-up
Sensor (indicated by a dotted line). Remove the foreign object from the Media Take-up Sensor
path. Arrange the Basket Cloth and Basket Rod so they do
not interfere with the Media Take-up Sensor.