HP XP Data Shredder Software - Manual (Page 152)

Connecting XP12000/XP10000 Disk Arrays
When connecting an XP12000/XP10000 Disk Array as the external array, you must set the external
array port host group for one of two types of Windows hosts (host mode 0C: Windows, host mode 2C:
Windows Extension).
Also, the port attribute must be the target or RCU target port.
Path status and examples of recovery procedures (XP12000/XP10000 Disk
Arrays)
Table 21 shows examples of recovery procedures when the path status is not normal. When the path
status is not normal, see Troubleshooting External Storage XP and this table to recover the path status. If
you cannot restore the path, contact your HP account support representative.
152 Notes on connecting external arrays