HP XP Data Shredder Software - Manual (Page 88)

If you already stopped the application, go to step 14. If you have not stopped the application, click
Cancel to close the message pane, stop the application, and retry the operation.
14. Click OK. A confirmation message appears.
15. Click OK. The mapping set in the Add LU window is applied to the local array, and the specified
contents appear in the Device list.
If errors occur during the external LU mapping operation, failed settings and error codes appear in
the Preset list. To check error messages, right-click the failed setting, and select Detail.
Mapping multiple external LUs at (Add LU (Auto))
This section describes the procedure to map multiple external LUs at one time. The procedure starts with
the Add LU (AUTO) command.
NOTE:
Before mapping the external LU, you must check whether any application (for example, RAID Manager
XP) using the command device is in progress. If any application using the command device is in
progress, stop the application.
When mapping multiple external LUs at one time, the CU:LDEV numbers for the mapped destination
internal LDEVs are assigned in a series. When performing the mapping operation, you can select the first
CU:LDEV number for the mapped destination internal LDEVs. External Storage XP assigns the selected
CU:LDEV number as the first mapped destination LDEV, and as many subsequent CU:LDEV numbers are
kept for mapping as the number external LUs required to be mapped. To automatically perform the
mapping operation, you can let External Storage XP select the first CU:LDEV number.
NOTE:
If you set Interval for the mapping, the CU:LDEV number of the internal LDEV that must be mapped
is set to the specified interval value.
CAUTION:
If the LUs you are mapping include a volume with the VMA setting, you cannot use the Add LU (AUTO)
command to map them at one time.
Use the Auto Map Setting and Select LDEV windows ( Figure 49 ) for mapping multiple external LUs
at one time.
88 Configuring external LUs