HP XP Data Shredder Software - Manual (Page 87)

8. Click OK. The Add LU pane appears.
9. When all settings are complete on the Add LU window, click OK.
• If you need to set the SSID, the SSID window appears. Go to step 10.
Figure 46 SSID window
• If the SSID setting is not necessary, the Add LU window closes, and the LU Operation pane
appears. Settings appear in blue italics in the Device tree and Device list. Contents specified
in the Add LU window appear in the Preset list. To check setting details, right-click the setting
in the Preset list, and select Detail. To cancel settings, right-click the setting in the Preset list,
and select Delete. Go to step 13.
10. If you need to set an SSID to the mapped internal LDEV, the SSID pane appears. When storage
is partitioned using XP Disk/Cache Partition, select the SLPR number in the SLPR box. If you select
the Limited check box and select the SLPR number, you can set only SSIDs that can be used for the
selected the SLPR. If you do not select the Limited check box, you can set the SSID from all unused
SSIDs regardless of the selected SLPR number. Right-click the CU:LDEV number on the SSID pane, and
select Set SSID. The Set SSID window appears.
Figure 47 Set SSID window
11. Enter the SSID. If you selected the Limited check box on the SSID window, only SSIDs that can be
used in the SLPR selected on the SSID pane appear in the drop-down list. If you did not select the
Limited check box on the SSID pane, all unused SSIDs appear in the list, regardless of the selected
SLPR. You can enter 0x0004 to 0xFFFE as an SSID.
12. Click OK. The Set SSID window closes, and the LU Operation pane appears.
Settings appear in blue italics in the Device tree and Device list and also appear in the Preset list. To
check setting details, right-click the setting in the Preset list, and select Detail. To cancel settings,
right-click the setting in the Preset list, and select Delete.
13. Click Apply. A confirmation message appears.
External Storage XP user guide 87