HP XP P9500 Storage - Manual (Page 60)

2. Click to change the mode from View to Modify.
3. In the Display box, select Port.
4. In the list of ports, right-click the port that you want to change and select the desired port type:
Initiator, RCU Target, or Target).
5. When you are finished defining ports, review the Preview list.
•
To change a setting, right-click the port in and select the attribute.
•
To delete a setting, right-click the port and select Delete.
6. Click Apply to save your modifications in the system.
Configuring local and remote systems for Cnt Ac-J Z
You associate the primary and secondary systems in the Continuous Access Journal Z relationship
and define the logical paths between them in one procedure.
Prerequisite information
•
This procedure must be performed on both primary and secondary systems
•
The primary and secondary systems must already be configured for Continuous Access Journal
Z operations. See
“System requirements” (page 16) for more information.
•
The data path must be set up. See “Planning the data path” (page 41) for more information.
•
The port attributes on the primary and secondary systems must be configured for Cnt Ac-J Z.
See
“Defining fibre-channel port attributes ” (page 59) .
•
The system's serial number, LDKC number, controller ID, Path Gr. ID, and port number will be
required during this procedure.
•
Logical path settings are required in order to perform Continuous Access Journal Z pair
operations and check pair status in Remote Web Console. Make sure to complete the
60 Configuration operations