HP LaserJet P4015 Printer series - Manual (Page 167)

Control panel message Description Recommended action
To use another tray press OK
alternates with
MANUALLY FEED [TYPE] [SIZE]
For help press
MANUALLY FEED OUTPUT STACK
Then press OK to print second sides
The first side of a manual duplex job has been
printed and the product is waiting for you to
insert the output stack to complete the
second side. 1. Load the output stack into Tray 1,
maintaining the same orientation with
printed side down.
2. To continue printing, press OK .
No job to cancel
The stop button was pressed, but there is
no active job or buffered data to cancel.
The message is displayed for approximately
2 seconds before the product returns to the
ready state.
No action is necessary.
NON HP SUPPLY INSTALLED
Economode disabled
The product has detected that the print
cartridge is not a genuine HP supply. If you believe you purchased a genuine HP
supply, call the HP fraud hotline
Any product repair required as a result of
using non-HP supplies or unauthorized
supplies is not covered under the product
warranty.
To continue printing, press OK .
NON HP SUPPLY INSTALLED
alternates with
For help press
The product has detected that the print
cartridge is not a genuine HP supply. If you believe you purchased a genuine HP
supply, call the HP fraud hotline.
Any product repair required as a result of
using non-HP supplies or unauthorized
supplies is not covered under the product
warranty.
To continue printing, press OK .
Output bin FULL
Remove all paper from bin
The output bin is full, and printing cannot
continue. Empty the bin so that the current print job can
finish.
Output bin FULL
Remove all paper from bin
alternates with
<Current status message>
The output bin is full, but it is not needed for
the current print job. Empty the bin before sending a job to that bin.
PAPER WRAPPED AROUND FUSER
For help press
A jam has occurred because paper has
wrapped around the fuser. CAUTION: The fuser can be hot while the
product is in use. Wait for the fuser to cool
before handling it.
1. Turn the product off.
2. Remove the rear output bin.
3. Press the blue tabs to remove the fuser.
4. Remove the jammed paper.
Table 10-1 Control-panel messages (continued)
ENWW Interpret control-panel messages 155