HP LaserJet P4015 Printer series - Manual (Page 43)

Menu item Sub-menu item Sub-menu item Values and Description
SUBNET MASK: The subnet mask for the printer,
where m is a value from 0 to 255.
DEFAULT GATEWAY: The IP address of the gateway
or router used for communications with other networks.
DEFAULT IP Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
AUTO IP: A link-local IP address 169.254.x.x is set.
LEGACY: The address 192.0.0.192 is set, consistent
with older HP Jetdirect products.
PRIMARY DNS Specify the IP address (n.n.n.n) of a Primary DNS
Server.
SECONDARY DNS Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 SETTINGS ENABLE Use this item to enable or disable IPv6 operation on the
print server.
OFF*: IPv6 is disabled.
ON: IPv6 is enabled.
ADDRESS Use this item to manually configure an IPv6 address.
MANUAL SETTINGS: Use the MANUAL SETTINGS
menu to enable and manually configure a TCP/ IPv6
address.
ENABLE: Select this item and choose ON to enable
manual configuration, or OFF to disable manual
configuration.
ADDRESS: Use this item to type a 32 hexadecimal
digit IPv6 node address that uses the colon
hexadecimal syntax.
DHCPV6 POLICY ROUTE SPECIFIED: The stateful auto-configuration
method to be used by the print server is determined by
a router. The router specifies whether the print server
obtains its address, its configuration information, or
both from a DHCPv6 server.
ROUTER UNAVAILABLE: If a router is not available,
the print server should attempt to obtain its stateful
configuration from a DHCPv6 server.
ALWAYS: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
PRIMARY DNS Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
SECONDARY DNS Use this item to specify an IPv6 address for a
secondary DNS server that the print server should use.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
ENWW Configure Device menu 31